Test menu for distance calibration [RESOLVED]
Posted: Sun Mar 08, 2020 7:31 pm
I was looking for answers on the Internet to fix the issue with the distance sensor - while talking the screen sometimes erratically switches on and you can accidentally end the call with your cheek. This can be fixed by re-calibrating the distance sensor.
To enter the test menu use the same code as for the other models in the 9500 family:
1. Open Phone call menu [as if you would call someone]
2. click the manual dial menu [at the bottom]
3. key in this code: *#87#
4. The factory menu should open [you will know when you see it]
5. On this screen select MMI2 or MMI4 [this is where it differs from other models]
6. Select Single Test
7. Find and select Distance Calibration [color=#2980b9][about the middle of the screen][/color]
8. Follow the instructions on the screen. A demonstration how to do it can be found here:
Hope this is useful for someone,
Regards
All credit to the guy who made the YT video!
To enter the test menu use the same code as for the other models in the 9500 family:
1. Open Phone call menu [as if you would call someone]
2. click the manual dial menu [at the bottom]
3. key in this code: *#87#
4. The factory menu should open [you will know when you see it]
5. On this screen select MMI2 or MMI4 [this is where it differs from other models]
6. Select Single Test
7. Find and select Distance Calibration [color=#2980b9][about the middle of the screen][/color]
8. Follow the instructions on the screen. A demonstration how to do it can be found here:
Hope this is useful for someone,
Regards
All credit to the guy who made the YT video!
Good! Good! Good!