Page 1 of 3
[FEATURE REQUEST] Intercom App Additions
Posted: Tue Jan 15, 2019 5:05 am
by CallMeColt
Hello,
I purchased the phone to use the UHF radio built in but it is lacking some features that would be nice to have & add functionality to the phone.
One would be to add the ability for "tones" when editing a channel. This is used for repeaters. I have been unable to get a repeater to work on the app due to this.
The other would be to add a digital Morse Code ability. Set it up so you can type a message & tap send, then it sends out as a Morse Code. Then, have a setting to translate the Morse code when it is received. This would be extremely helpful in man situations.
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Tue Jan 15, 2019 11:41 pm
by blackview_admin
Will forward that to the tech team
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Wed Jan 16, 2019 9:06 pm
by bpz1970
Hello. The option for editing tones is present actually. When editing an analog channel, in the part where you see RecvsubAudio you must select CTCSS instead of the Wave option (the same applies for SendsubAudio). Once you have the CTCSS option selected then you will be able to select your desired subtones.
I'm attaching a chart of subtone frequencies.
Good luck!
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Thu Jan 17, 2019 8:20 pm
by CallMeColt
bpz1970 wrote:Hello. The option for editing tones is present actually. When editing an analog channel, in the part where you see RecvsubAudio you must select CTCSS instead of the Wave option (the same applies for SendsubAudio). Once you have the CTCSS option selected then you will be able to select your desired subtones.
I'm attaching a chart of subtone frequencies.
Good luck!
Okay, great! I did see that it had that option but the numbers made no sense. With this chart, it does now. Thanks!!
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Mon Jan 28, 2019 3:43 pm
by stenfo777
Hi, i bought this phone to use the intercom connected with my bluetooth paramotor helmet, but i can only use the headphones of the bluetooth headset and not the mic...will be nice if in the future would be implemented...
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Mon Jan 28, 2019 5:31 pm
by Cilone
I was looking forward this chart! Thank you!
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Thu Jan 31, 2019 8:26 pm
by Helpless
That list is not correct.....
Use the link below and use the 50 new Yaesu codes.
http://www.repeater-builder.com/tech-in ... chart.html
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Sat Feb 02, 2019 5:15 am
by Andrew ZS2AFB
Just a suggestion is to display the
Tone Freq. (Hz) "88.5Hz" In stead of the numbers then it will be very clear as to which tone code is being used
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Sat Feb 02, 2019 1:06 pm
by CallMeColt
Helpless wrote:
Great list, thank you.
Re: [FEATURE REQUEST] Intercom App Additions
Posted: Fri Feb 08, 2019 2:19 am
by CallMeColt
Andrew ZS2AFB wrote:Just a suggestion is to display the
Tone Freq. (Hz) "88.5Hz" In stead of the numbers then it will be very clear as to which tone code is being used
Yes, this would make it much easier.