69mustang wrote:Ok I've just replaced the charging board in a BV9000 pro. It's not as straight forward as it looks. Unclip the gps plug then unsolder the speaker. then unsolder the mic then unclip the ribbon connector and then undo the only screw. sounds easy ???. Nah. Then the reverse with the new board sounds easy "eh". So I turned it on and all good but no speaker sound "F" so I checked all the solder joints all good. So lucky for me I bought three new boards and fitted another new one But still the same "F" So I figured that I may have damaged the speaker on removal. so I checked online and couldn't find one the same. So I thought that I had better reassemble it till I could find a new one. But as soon as the last couple of screws were tightened the speaker started working. I had a similar problem with a AGM X1 so keep that in mind
Hi there, please keep in mind that this is the bv8000 pro forum section.